I don’t understand how to change the baudrate in SARA-N210 modem. I send “AT+NATSPEED=115200” and I get a response, but the baud rate value immediately changes to 9600, a factory set value.
I read through the manual, it mentions you need to enter some special mode to store those settings in the NVM, but I am still not able to get the baudrate to persist.
Does anyone know the exact steps to store the new baudrate?
Hi @annabanana ,
Did you check if your module has the latest firmware?
Maybe your issue is resolved in a firmware update.
SARA-N2 series | u-blox (u-blox.com)
Best regards,
Jan